Balde 100cc Amtech NC-559-ASM-TPF(UV) solder flux original

L'Amtech NC-559-ASM-TPF(UV) és un flux sense neteja (no-clean) amb baixa activació química, cosa que minimitza residus i redueix el risc de corrosió en components electrònics. Es diferencia de fluxes base colofònia o àcids perquè no requereix una neteja exhaustiva post-soldadura, afavorint treballs de retraball i soldadura SMD on la neteja pot danyar components sensibles.

El producte es presenta en un pot de 100 cc (centímetres cúbics), equivalent aproximadament a 100 mL. El pes del flux en si ronda els 120 g, depenent del lot. El recipient normalment mesura 7 cm de diàmetre per 6 cm d'alçada, tot i que pot variar lleugerament segons el fabricant.

L'Amtech NC-559-ASM-TPF(UV) està formulat com a 'no-clean', és a dir, els residus poden romandre a la placa sense provocar fallades elèctriques ni corrosió, segons proves d'estàndards IPC. Tanmateix, en aplicacions d'alta fiabilitat o circuits estratègics, es pot optar per neteja amb isopropanol per assegurar els màxims estàndards.

La vida útil típica del flux Amtech NC-559-ASM-TPF(UV) sense obrir és de 12 a 18 mesos des de la data de fabricació. S'ha d'emmagatzemar en un lloc fresc (idealment entre 5 °C i 10 °C) i protegit de la llum solar directa per prevenir la polimerització o canvis en la viscositat. Un cop obert, s'ha de tancar hermèticament per evitar contaminació i assecat ràpid.

Amtech NC-559-ASM-TPF(UV) is a no-clean flux with low chemical activation, which minimises residue and reduces the risk of corrosion in electronic components. It differs from rosin-based or acidic fluxes because it does not require thorough post-solder cleaning, making it ideal for rework and SMD soldering where cleaning could damage sensitive components.

The product comes in a 100 cc container, equivalent to approximately 100 mL. The flux itself weighs around 120 g, depending on the batch. The container normally measures 7 cm in diameter by 6 cm in height, although this may vary slightly by manufacturer.

Amtech NC-559-ASM-TPF(UV) is formulated as no-clean, meaning the residues can remain on the board without causing electrical faults or corrosion, according to IPC standard tests. However, in high-reliability applications or critical circuits, cleaning with isopropanol may be chosen to ensure the highest standards.

The typical shelf life of unopened Amtech NC-559-ASM-TPF(UV) flux is 12 to 18 months from the date of manufacture. It should be stored in a cool place (ideally between 5°C and 10°C) and protected from direct sunlight to prevent polymerisation or changes in viscosity. Once opened, it should be sealed tightly to avoid contamination and rapid drying.

Amtech NC-559-ASM-TPF(UV) is a no-clean flux with low chemical activation, which minimises residue and reduces the risk of corrosion on electronic components. It differs from rosin-based or acidic fluxes because it does not require thorough post-solder cleaning, making it ideal for rework and SMD soldering where cleaning could damage sensitive components.

The product is supplied in a 100 cc container, equivalent to approximately 100 mL. The flux itself weighs around 120 g, depending on the batch. The container normally measures 7 cm in diameter by 6 cm in height, although this may vary slightly by manufacturer.